Ipv4 Source Guard; Configuring Ports For Ipv4 Source Guard - Edge-Core ECS3510-10PD Management Manual

| Security Measures
C 13
HAPTER

IPv4 Source Guard

IP 4 S G
V OURCE UARD
C
ONFIGURING
P IP 4
ORTS FOR V
S G
OURCE UARD
IPv4 Source Guard is a security feature that filters IP traffic on network
interfaces based on manually configured entries in the IP Source Guard
table, or dynamic entries in the DHCP Snooping table when enabled (see
"DHCP Snooping" on page
traffic attacks caused when a host tries to use the IP address of a neighbor
to access the network. This section describes how to configure IP Source
Guard.
Use the Security > IP Source Guard > Port Configuration page to set the
filtering type based on source IP address, or source IP address and MAC
address pairs.
IP Source Guard is used to filter traffic on an insecure port which receives
messages from outside the network or fire wall, and therefore may be
subject to traffic attacks caused by a host trying to use the IP address of a
neighbor.
CLI R
EFERENCES
"ip source-guard" on page 928
◆
C U
OMMAND SAGE
Setting source guard mode to SIP (Source IP) or SIP-MAC (Source IP
◆
and MAC) enables this function on the selected port. Use the SIP option
to check the VLAN ID, source IP address, and port number against all
entries in the binding table. Use the SIP-MAC option to check these
same parameters, plus the source MAC address. If no matching entry is
found, the packet is dropped.
Multicast addresses cannot be used by IP Source Guard.
N :
OTE
When enabled, traffic is filtered based upon dynamic entries learned via
◆
DHCP snooping (see
addresses configured in the source guard binding table.
If IP source guard is enabled, an inbound packet's IP address (SIP
◆
option) or both its IP address and corresponding MAC address (SIP-
MAC option) will be checked against the binding table. If no matching
entry is found, the packet will be dropped.
◆ Filtering rules are implemented as follows:
If DHCP snooping is disabled (see
■
check the VLAN ID, source IP address, port number, and source
MAC address (for the SIP-MAC option). If a matching entry is found
in the binding table and the entry type is static IP source guard
binding, the packet will be forwarded.
– 404 –
415). IP source guard can be used to prevent
"DHCP Snooping" on page
page 418), IP source guard will
415), or static