Table of Contents
Advertisement
Click Apply.
5.
Figure 330: Configuring a Static IPv4 Address
To obtain an dynamic IPv4 address through DHCP/BOOTP for the switch:
Click System, IP.
1.
Select Configure Interface from the Action list.
2.
Select Add Address from the Step list.
3.
Select the VLAN through which the management station is attached,
4.
set the IP Address Mode to "DHCP" or "BOOTP."
Click Apply to save your changes.
5.
Then click Restart DHCP to immediately request a new address.
6.
Figure 331: Configuring a Dynamic IPv4 Address
The switch will also broadcast a request for IP configuration settings
N
:
OTE
on each power reset.
– 577 –
C
15
HAPTER
Setting the Switch's IP Address (IP Version 4)
| IP Configuration
Advertisement
Chapters
Table of Contents
