Advertisement
4600 IP Phone Installation
Installation Requirements
4600 Series IP Telephone Installation
IP Office
To install a 4600 Series IP Telephone onto IP Office, the following items
are required:
•
Power Socket:
A switched 110-240V AC, 50-60Hz, 250-500mA supply socket is
required for each IP telephone.
•
LAN Socket:
A 10/100Mbps RJ45 Ethernet LAN connection point is required for each
IP telephone.
•
LAN Cables:
Check that an RJ45 LAN cable has been supplied with the IP telephone
for connection to the power unit. You will also need an additional RJ45
LAN cable for connection from the power unit to the customer LAN.
•
An additional RJ45 LAN cable can be used to connect the user's PC
to the LAN via the IP telephone.
•
1151A1 Power Unit:
This unit supplies power via the LAN cable to the IP telephone.
•
Voice Compression Module:
The IP Office Control Unit must be fitted with a Voice Compression
Module. The size of the module will limit the number of simultaneous
VoIP calls.
•
DHCP Server:
The IP Office Control Unit can perform this role unless another DHCP
server already exists.
•
TFTP Server:
The PC running the Manager application can perform this role. The
TFTP server is only required during IP telephone installation and
maintenance.
•
H323 Gatekeeper:
The IP Office Control Unit can perform this role unless a third party
gatekeeper already exists.
•
IP Office Manager PC:
A PC running Manager is required for Control Unit configuration
changes.
•
IP Telephone Software:
The software for IP telephone installation is supplied on the IP Office
Administration CD.
•
Licence Key:
The 4600 Series IP telephones do not need a licence key entered on
the system.
40DHB0002UKCJ - Issue 5 (08/03/2002)
Page 4
Page 4
Advertisement
