Factory Five Racing Mk3 Roadster Assembly Manual page 86

94-95 Fuel Injected Applications
Use the accelerator cable without modification. Follow the installation instructions above.
Carburated applications
1. Insert the pedal end of the cable into the foot box.
2. Screw on and tighten the
3. Hold the accelerator pedal up to the mount on the ¾" tube at the front of the foot box. The higher you
can mount the pedal the better the pedal will be positioned on your foot. The key things to watch for
is clearance between the accelerator pedal and clutch quadrant stop and keeping the cable straight so it
will not rub on the side of the cable sheath. If a higher location is desired, some material can be
removed from the bottom of the clutch quadrant stop. If mounting higher, mark and drill new holes
for the bolts in the pedal.
4. Attach the accelerator pedal to the mount using the ¼"x ¾" bolts, washers and lock nuts.
5. Cut the accelerator pedal capture in the corner using a pair of wire cutters.
6. Slip the accelerator cable through the cut so that the ball will sit in the recess as shown.
7. Push the capture into the end of the throttle pedal.
8. Attach the cable sheath to your cable mount on the engine.
9. If necessary, attach the supplied ball stud to the carburetor in the appropriate location. Refer to the
carburetor instructions for placement.
10. Attach the ball stud retainer to the ball stud.
11. Pull the cable tight holding the cable against the ball stud retainer. Align the ball stud retainer with
the cable as if the cable was going into the retainer.
12. Mark on the cable where the retainer ends.
13. Measure ⅜" from the mark on the cable towards the end of the cable and re-mark the cable.
14. Using a pair of wire cutters, cut the cable at the new location marked.
15. Push and twist the ball stud retainer onto the end of the cable. Do not tighten the set screw yet.
Stop tab on accelerator pedal.
/ " locknut on the cable sheath inside the foot box using two ½" wrenches.
5
16
86
www.factoryfive.com 508-291-3443