Table of Contents
Advertisement
4. Position the brackets at the correct angle before tightening. Use a ¾" socket and ¾" combination
wrench to tighten the bolts.
5. The seat belt quick release latch should be on the right side if you are right handed, left if you are a
lefty.
1. Install the seats in the holes made earlier. Flip the seat forward and attach using fasteners. Do not
torque the screws to more than 20lb/ft.
2. Now is a good time to finish off the lower door openings (door sills).
3. Cut the door press-on trim in half and press over the body lip and carpet edge.
4. The weather-strip should start at the bottom of the door hinge area and go back along the doorsill to
just below the latch. The trim presses down over the lip of the doorsill and carpet edge.
TOOLS: ⅛" Drill bit, Drill, Philips head screwdriver
PARTS: Emergency brake boot (FFR# 10879), Screws (FFR# 13979).
1. Pull the handle cover over the handle.
2. Hold the cover in place and drill ⅛" holes through the ring that is captured in the boot and the cockpit
aluminum.
3. Attach the boot to the cockpit aluminum using the screws provided.
Attaching harness to frame mounts.
Final Seat Installation
Emergency Brake Boot Installation
178
www.factoryfive.com
508-291-3443
Advertisement
Table of Contents
