Hood Pins - Factory Five Racing Mk3 Roadster Assembly Manual

ATTENTION: This kit is only a collection of parts designed for use primarily as a race car. Applying
the license plate bracket does not mean that this vehicle is street legal. Factory Five Racing does
not build completed or partially completed street vehicles. If you choose to title, register and
operate your kit on public roads, you are responsible for ensuring that the vehicle you build
complies with all Federal, Sate and local laws regarding its use. The inclusion of the license
plate bracket does not indicate that this kit complies in any way with these laws.
TOOLS: Drill, 3 / ", ⅜" drill bits, masking or clear tape.
16
PARTS: License light/bracket components (FFR# 11041).
1. Position the template (found in Appendix A) on the flat area on the edge of the outside of the trunk
lid.
2. Affix the template to the trunk with tape.
3. Use the / " drill bit for the small holes.
3
16
4. Use the ⅜" drill bit for the large hole.
5. Remove the template.
6. Test fit the part.
TOOLS: Drill, / ", /
3 7
32 16
PARTS: Three lock set and fasteners (FFR# 11019), hood/trunk fasteners (FFR# 10646).
1. At the front side corners of the engine bay, on the ¾" frame tubing, there are steel mounting plates
which to attach the hood pin vertical mounting plates.
Trunk License Plate Light Hole Cut-Outs
Drilling the license plate light holes in the trunk
" drill bits, Phillips head screwdriver, (2)
www.factoryfive.com

Hood Pins

/ " combination wrenches.
11
16
121
508-291-3443
.