Table of Contents
Advertisement
16. Once the ride height is set, tighten the small set screw in the spring seat just until you feel it contact.
The end of the set screw is plastic so that the threads are not destroyed. Not a lot of pressure is
needed to prevent the seat from turning.
ATTENTION:
• Like the suspension and fuel/brake lines, you will be trusting this assembly with your life. Use
extra care when doing the final assembly.
• If you are doing a Complete Kit build, makes sure that you use the Front Footbox panel packed
with the Wilwood Pedal box assembly
TOOLS:
/
",
/
",
5
3
5
32
16
screwdriver, 15mm deep socket.
PARTS: Steering system hardware (FFR# 11073), Box 9A Steering shaft assembly (14453), pillow
block/hardware (FFR# 11072).
1. Install the driver's side foot box front aluminum vertical wall (FFR# 10904) using the factory screws
to position it. Make sure all of the holes are aligned.
2. Remove the panel.
3. Apply silicone to the aluminum. Do not silicone along the front ¾" tube as inside wall will go behind
this panel later.
4. Reinstall the panel with the screws and clamp the front panel to the steel plate so the silicone can dry.
5. Mount the ¾" upper pillow block to the bracket on the back of the 2"x 2" tube. Make sure the locking
collar is on the front side. Again, use a
the bolts completely, allow the bearing to swivel in the bracket.
Overhead view looking down onto upper steering pillow block installed on frame 2"x 2" dash support
Steering Shaft
/
" hex key, ½",
/
", 10mm wrench, marker, drill,
9
16
16
/
5
16
www.factoryfive.com
" hex key,
/
" wrench and the kit fasteners. Do not tighten
9
16
50
508-291-3443
/
" drill bit, Philips head
3
16
.
Advertisement
Table of Contents
