Factory Five Racing Mk3 Roadster Assembly Manual page 101

5. Use screws provided with kit to mount the vacuum controls and BAP (Barometric Air Pressure)
sensor to the firewall.
ATTENTION: Note: The BAP sensor is similar to a MAP sensor used on speed density cars except it
does not get hooked up to a vacuum source, it is left open to the air.
6. Attach the computer connectors to the starter solenoid and the ground to the backside of the solenoid
against the ¾" tubing. The ground looks like a female stereo jack (sort of). The other half of the
connector is on the battery negative cable, so just cut the connector off and use the ring connector.
Engine harness passing through firewall extension.
Computer ground near driver's foot box
101
www.factoryfive.com 508-291-3443