Fuel Tank And Fuel Filter - Factory Five Racing Mk3 Roadster Assembly Manual

ATTENTION: Extreme caution should be used when handling and storing fuel tanks that contain fuel.
Make sure to close off the tank with the factory cap and seal the fuel line ends. Keep the tank
level.
TOOLS: " and "deep sockets, combination wrenches, rubber mallet, hammer,
9 5
/ /
16 16
friend.
PARTS: Donor fuel tank, mounting straps, fuel line from tank to filter and fuel neck. Secondary Body
Fasteners Assembly (FFR# 10788), Fuel strap fasteners (FFR# 10896), fuel line components
(FFR# 11078), fuel lines.
1. Put the four square plastic plugs (FFR# 14161) into the ¾" vertical frame extensions under the trunk
area (these are the open ended tubes that stick straight down from the floor of the trunk steel
framework). The plastic caps prevent the metal tube from touching the fuel tank edge flange.
2. Place the plastic cover on the fuel tank bottom (if not already in position) and position the tank behind
the trunk so that the fuel filler neck is on the passenger's side.
Item
Front
Front lower control arm to frame
Front lower ball joint to spindle
Upper A-arm to frame
Upper ball joint to IFS bracket
IFS bracket to spindle
Rear
Upper control arm to axle
Item
Upper control arm to frame
Lower control arm to axle
Lower control arm to frame
Lower vertical shock to axle bracket
Quad shock bracket to frame
Quad shock to bracket
Quad shock to axle

Fuel Tank and Fuel Filter

Cap Plug
www.factoryfive.com
Nm
135-162
106-163
135-162
95-122
135-162
95-135
Nm
101-111
101-111
101-111
61-81
63-67
63-67
63-67
Cap Plug installed
59
508-291-3443
Lbft
100-110
80-120
100-110
70-90
100-110
70-100
Lbft
75-82
75-82
75-82
45-60
47-50
47-50
47-50
" hex key, floor jack,
5
/
16