Table of Contents
Advertisement
4. Raise the body up above the rolling chassis.
5. While holding the rear end of the body above the rear of the chassis, lower the nose section down,
making sure that the
brake vent slots. The quick jack and body mount plate does not go through the brake vent holes nor
does it go through the front nose openings.
6. Gently lower the rear tail section of the body. At the same time, have someone at the front of the
body push the body towards the back of the car. Stretch the body slightly to clear the trunk aluminum
and the door hinge mounts.
7. Pull the sides of the body outwards slightly to clear the 2"x 2" outriggers and lower the body.
8. Work from the rear of the car towards the front.
9. Use the original body mounting holes to line things up.
Lowering a painted body down onto the completed chassis.
/
" bent steel plates (the front quick jack bumpers fasten to these) are not in the
1
16
www.factoryfive.com
125
508-291-3443
Advertisement
Table of Contents
