Factory Five Racing Mk3 Roadster Assembly Manual page 47

6. Slide the rubber bumper about two inches down on the shaft.
7. Put the spring on the shock, then install the spring hat on the shaft end of the shock and push the
rubber bumper up against it.
8. Rotate the spring seat back up the sleeve so that the spring pushes the hat tight against the end of the
shock.
9. Install the snap ring on the spring hat so that it holds onto the shock end. Make sure that the slot in
the snap ring and the slot in the spring hat are not aligned.
47
www.factoryfive.com 508-291-3443