Factory Five Racing Mk3 Roadster Assembly Manual page 169

11. Push the rubber gasket on the back of the bucket.
12. Hold a headlight up to the body holes cut earlier and use the bucket holes as a template to mark the
screw holes.
13. Drill ⅛" mounting holes.
14. Screw on each headlight with four screws.
15. The trim ring slides down over the top of the light and is fastened at the bottom. This is a tight fit and
takes some effort to line up the lower screw hole.
16. Wire the headlights to the Mustang harness. The Mustang high beam is light green/black. The low
beam is red/black. On the headlight, there are three wires, black is ground, white is high beam and the
red is low beam.
Retaining ring screw mounted.
Attaching the headlight to the body.
169
www.factoryfive.com 508-291-3443