Table of Contents
Advertisement
TOOLS: ⅜", ¾",
/
" sockets,
7
16
socket, ½",
9
1. Bend the fuel lines away from the engine block just at the point where they are held in place by the
retaining clips. This is so that the fuel does not travel near the hot header. Don't make tight bends
here or it will affect your fuel flow.
2. If you are using a Lakewood bell housing, trim the area around the starter so that is flush with the
inspection cover.
3. If you are not running emissions equipment, the only engine controls that need vacuum are the PCV
valve in the valve cover and the fuel pressure regulator. The EGR can be left unhooked. Make sure
to close off any extra vacuum ports.
4. If you are not running emissions equipment, the hoses, mounts and solenoids can be removed.
5. Install the headers using the header originally for the left side on the right side of the engine, and the
right header on the left side of the engine. Thread all of the bolts on the headers before tightening any
of them, to make installation easier.
ATTENTION:
• If you are planning on using under drive pulleys, do not use the template.
• If you are planning on running power steering the alternate pulley is not needed. You will
however need the power steering mounting brackets for a non A/C car.
TOOLS: Cordless drill, ½" drill bit.
PARTS: Alternate drive pulley template, appendix A. On all EFI cars the pulley and fan belt replace the
A/C compressor and power steering pump.
1. Remove the A/C and power steering pump. Use the alternate drive pulley template to prepare the
bracket for the pulley.
2. Use the template in appendix A to drill into the original Mustang A/C bracket. If you are choosing to
run either A/C or power steering, you do not need to use this alternate drive pulley assembly.
3. If you really want power steering on the car (which is not necessary in a car this light) use the non-
A/C power steering brackets from Ford to move the power steering unit up out of the way of the
steering shaft.
/
" hex keys, regular screwdriver, Teflon tape, tube bender,
5
16
/
" combination wrenches,
16
Bending the fuel lines on the engine.
Alternate Drive Pulley Preparation
www.factoryfive.com
/
" drill bit, drill.
5
16
34
508-291-3443
/
" deep
9
16
Advertisement
Table of Contents
