Factory Five Racing Mk3 Roadster Assembly Manual page 116

TOOLS: 3.50" hole saw
1. Use the template in appendix A.
2. Cut the large circle out of the template.
3. Center the circle in the gas cap location.
4. Drill the 3.50" hole in the center of the cutout.
TOOLS: Hand jigsaw, marker pen and ruler.
1. At the factory, in the chassis assembly station, we drill two holes at each side of the body, forward of
the cockpit area and near the back top of the fender. These holes serve to locate the position of the
windshield cutouts. Use a ruler and marker to connect the outside edges of the two holes just forward
of the door openings.
2. Connect the two holes on the lines with a jigsaw to make an elongated oval.
Roll bar holes cut out with roll bar installed
Gas Filler hole
Windshield Cut-Outs
116
www.factoryfive.com 508-291-3443
.