Factory Five Racing Mk3 Roadster Assembly Manual page 240

5. Once the hole has been drilled, install the Panhard mount. Tighten all nuts.
6. Install a jam nut on each of the rod ends, remembering that two of them are left hand thread.
7. Thread each rod end into the Panhard bar and upper arm until approximately ¼" of thread is showing
between the jam nut and end of the rod end.
8. Mount the panhard bar to the car using the ⅝"x 3" bolts and spacers. Install the panhard bar into the
passenger side traction lock bracket. Three spacers are used in the front (2) @ 0.375" (FFR# 14064)
and (1) @ 0.25" (FFR# 14065). The rear uses the thin 0.0625" shim (FFR# 13337). It will be
necessary to adjust the length some to fit, make sure that you adjust the same amount on both sides.
There should never be less than ¾" of threads screwed into either the Panhard bar or the upper arm.
Driver's Side Competition Traction-lok bracket
Panhard bar and upper arm.
240
www.factoryfive.com 508-291-3443