Suggested Parts - Factory Five Racing Mk3 Roadster Assembly Manual

20. Level the motor using the intake manifold or the back of the bellhousing, this is important in order for
the side exhaust to line up correctly with the body as well as for valve cover clearance on the drivers
side.
21. The headers should be fitted to the engine after it has been lowered into place. Wait to mount the side
pipes until after the body has been fitted. The exhaust gaskets for the side pipes will need to be cut
from the material provided, it is all right to have excess material on the outside of the flange but try to
keep the inside flush with the tubes.
V. Wiring Harness
1. The wiring harness that comes with the kit is labeled for all the circuits necessary to complete the car
with the exception of an electric fuel pump. If you plan on running an electric pump and are not
going to be installing a radio then this circuit can be used to trigger a relay for the pump. The
remainder of the harness should be run according to the instructions.
2. The ignition switch provided is for mounting in the dash on the right hand side underneath the smaller
gauges. The headlight switch can be place here as well or on the left side closer to the door.
3. Block off plates have been included in the kit for the holes where the fuel injection harness passes
through the firewall and transmission tunnel. The blockoff plate for the driver's side footbox hole can
be drilled to pass through the wires for the headlights and front turn signals. The grommet that comes
with the harness can be used here to keep the firewall sealed around the wires.
4. The Starter solenoid, coil, and ignition system can be mounted to the firewall for an uncluttered look
in the engine bay. There is a hole in the rear corner of the Drivers inside footbox wall for these wires,
as well as the rear taillight wires to pass through.
5. The fuse box mounts easiest above the drivers' footbox using the mounting hardware provided with
the harness. Wherever you mount the panel, make sure that you can easily access the fuses to replace
them.

Suggested Parts

The following parts are suggestions based on a combination of parts that we know to work. These parts
are not specifically required and some may be unnecessary depending on your combination.
Torque arm mount removed for crossmember clearance
234
www.factoryfive.com 508-291-3443