Table of Contents
Advertisement
7. Apply silicone to the flat surfaces of the frame where the aluminum will contact.
8. Re-install the aluminum panel.
9. Use #8 screws to hold the panel in place.
10. Drill through the aluminum rivet holes into the frame.
11. Wipe and clean the aluminum.
12. Rivet the panel in place with the short rivets.
13. Position the rear trunk floor.
14. The rear trunk floor is riveted in the same manner with rivets spaced every 2 - 3 inches along the 3/4"
tube framework. You can use the self-tapping screws to make this go faster, but final installation
must be done with the rivets.
15. Silicone around the seat harness mounts in the trunk.
ATTENTION: The 99-04 Parking brake handle has different mounting locations and "T" cable length
than the older 87-98 handles.
TOOLS: ½" deep socket,
PARTS: Black vinyl trim (FFR# 13990), brake line components (FFR# 11076).
Emergency Brake cables
1. The emergency brake cables are run from the rear axle forward in front of the spring mounts and
through the triangular area between the ¾" tube and the 2"x 3" tubes.
Parking brake cable passing through triangle and in front of coil spring on driver's side
2. Next, go over the upper control arms and rear-end to the transmission tunnel area of the car. In the
tunnel, there are two brackets with two holes mounted to the frame. The bracket closest to the handle
is for 93-04 length cables while the other is for 87-92 cables.
Emergency Brake Handle and Cables
/
" hex key, marker, scissors, hacksaw.
3
16
106
www.factoryfive.com
508-291-3443
Advertisement
Table of Contents
