Table of Contents
Advertisement
17. Drill ¼" holes through the top of the ¾" tubes only, at the bolt locations marked.
18. Insert the "J" bolts into the tubes so that the threaded part sticks straight up.
19. Position the battery box with battery between the bolts and place the crossbar over the bolts.
20. Attach the battery cables to the battery so that they exit the box in the desired location.
21. Place the cover over and onto the "J" bolts.
Put washers and the locknuts on the bolts and tighten them evenly until the box does not move.
22. Run the battery cable (FFR# 10579) from the positive terminal of the battery straight forward, down
the driver's side of the transmission tunnel to the floor/tunnel wall bend and along the edge to the
front of the driver's foot box. Zip tie as you go.
23. Run the cable under the floor to the outside of the car and up to the ¾" tube next to the master
cylinder. Wrap the end of the cable with electrical tape to prevent any short-circuiting.
24. Use some of the white press-on plastic grommeting (included in the kit) on the edge of the aluminum
to prevent cable damage.
25. Attach the cable to the side of the foot box and the floor using kit zip ties.
26. Drill two
/
" holes and pass the zip ties through one hole, inside the car then through the other hole
3
16
and fasten it.
27. Leave the battery cable fastened for now with zip ties everywhere so that the rear harness can be run
with the cable later. Use the rubber insulated clips and screws for final assembly.
ATTENTION: The air tube assembly should be used on computer-controlled engines. Improper or
incomplete installation of air tubes or vacuum lines may result in emissions level problems.
TOOLS: ¾", ⅜" sockets,
socket,
/
", ½" combination wrenches, ⅛" drill bit, drill.
9
16
PARTS: Oil filter relocating kit (FFR# 10992)
1. If you are installing aftermarket gauges, some of the gauge sending units will need to be changed. Do
this now while the engine is empty and out of the car. See your gauge instructions for more
information.
2. Install the oil filter relocate base plate to the engine. Place the O-ring in the adapter groove. If the O-
ring will not seat properly, put it in the freezer for 15 minutes and use a small amount of chassis
grease to hold it in place while spinning on the adapter. Tighten ½ turn after solid resistance is felt.
The outlets for the hoses should be facing towards the front of the engine.
Marking the bolt locations on the box top.
Engine Preparation
/
", ⅜" hex keys, regular screwdriver, Teflon tape, tube bender,
5
16
77
www.factoryfive.com
508-291-3443
/
" deep
9
16
Advertisement
Table of Contents
