Locating The Cause Of Scratching In The Film Platen; Guidelines For Removing The Causes Of Scratches - Kodak DryView 8150 Service Manual

7-6-4.

Locating the Cause of Scratching in the FILM PLATEN

1. Remove the IMAGING MODULE (paragraph 4-11-1).
2. Inspect the INNER GUIDE of the PLATEN for debris or burrs.
3. Use an ALCOHOL PAD to wipe down the INNER GUIDE.
4. See paragraph 7-6-5 for recommendations for removing the causes of scratches.
5. If you are unable to eliminate the cause of scratching in the PLATEN any other way, replace the
INNER GUIDE.
7-6-5.

Guidelines for Removing the Causes of Scratches

The location of the scratches on film is the best guideline for locating the problem area precisely in the
IMAGER. Observe the following suggestions:
1. Lightly rub the tips of your fingers over the suspected area. When you locate a burr or dirt, clean or
polish to remove it.
2. Turn several sheets of film upside down in a CARTRIDGE and transport them through the IMAGER.
Note
The back side of the film is more abrasive than the emulsion side and sometimes cleans off debris
that is hard to locate.
a. Under Proxy Server, uncheck "Use a proxy server."
3. After disabling the Proxy Server, connect to MPC again using the web browser.
4. If you cannot connect to MPC, advance to Step 1 in Message 2.
2005 July Rev. B 7F3318
Section 7 - - Troubleshooting
7-67