Kodak DryView 8150 Service Manual page 169

Service Manual
4-13. MCS ELECTRONIC COMPONENTS
This procedure removes the INTERLOCKS, CIRCUIT BOARDS, SERVICE OVERRIDE SWITCH, etc.
!
Caution
To avoid damage to sensitive ELECTRONIC COMPONENTS, always wear an ANTI-STATIC
WRIST STRAP when handling CIRCUIT BOARDS. CIRCUIT BOARDS contain lead and replaced
BOARDS must be returned to Kodak for rework, or disposed of properly.
Preliminary
Do the Preliminary procedure before doing any disassembly procedures.
1. Remove the SUPPLY CARTRIDGE.
!
Warning
When the POWER CORD is plugged in, hazardous voltages are present in some areas of the
IMAGER. These voltages can cause severe injury or death.
2. De--energize the IMAGER and disconnect the POWER CORD.
POWER SWITCH (Figure 4-51, Front View)
1. Lift the TOP HOOD.
2. Loosen 2 7--mm NUTS attaching the COVER for the TOP HOOD INTERLOCK and POWER SWITCH.
3. Slip down the COVER (slotted) to expose the POWER SWITCH.
4. Disconnect the WIRES and remove the POWER SWITCH.
TOP HOOD INTERLOCK (see Figure 4-51, Front View)
1. Lift the TOP HOOD.
2. Loosen 2 7--mm NUTS attaching the COVER for the TOP HOOD INTERLOCK and POWER SWITCH.
3. Slip down the COVER (slotted) to expose the INTERLOCK.
4. Remove 2 ATTACHING SCREWS and disconnect the WIRES to free the INTERLOCK.
FRONT DOOR INTERLOCK Switch (Figure 4-51, Front View)
1. Open the FRONT DOOR and remove the REAR PANEL.
2. Loosen the 4 SCREWS (2 each end) securing the IMAGING MODULE, and slide the MODULE out
the back of the IMAGER about 6 inches.
3. Open the PLATEN door from the front of the IMAGER.
4. Reach in through the PLATEN doorway to remove 2 SCREWS securing the INTERLOCK switch. Then
disconnect the ELECTRICAL PLUG to remove the SWITCH. Do not remove the whole INTERLOCK
ASSEMBLY.
DOOR RELEASE SOLENOID (Figure 4-51, Front View)
1. Open the FRONT DOOR.
2. Remove 4 SCREWS and disconnect the ELECTRICAL PLUG to remove the SOLENOID.
REAR PANEL INTERLOCK (Figure 4-51, Rear View)
1. Remove the REAR PANEL.
4-64
7F3318 2005 July Rev. B