Table of Contents
Advertisement
Service Manual
4-14-1. DRE HARD DRIVE, CD-ROM DRIVE, or FLOPPY DRIVE
Preliminary Disassembly
Note
If you are going to install a new HARD DRIVE, back up the system configuration to a FLOPPY
DISKETTE in your LAPTOP COMPUTER before proceeding. (See procedure 7-2-18 in
Troubleshooting.)
1. Remove the SUPPLY CARTRIDGE.
!
Warning
When the POWER CORD is plugged in, hazardous voltages are present in some areas of the
IMAGER. These voltages can cause severe injury or death.
2. De-energize the IMAGER and disconnect the POWER CORD.
3. Remove the DRE COMPUTER from the IMAGER and remove the COVER of the COMPUTER (see
procedure 4-14).
Removing the HARD DRIVE
4. Disconnect the POWER CABLE.
5. Disconnect the SIGNAL CABLE.
6. LOOSEN 4 spring-loaded SCREWS.
7. Remove the HARD DRIVE.
8. Check that the JUMPER on the new HARD DRIVE is set at the "Cable Select" position.
9. Assembly is the reverse of disassembly. When installing the 4 SCREWS, lift the HARD DRIVE slightly
to align the SCREWS with the holes in the DRIVE.
10. After installing a new HARD DRIVE and completing reassembly. Energize the IMAGER and check the
version of software on the DRIVE via the LOCAL PANEL.
11. If the software is not up to date, load (re--ghost) the current version of software onto the HARD
DRIVE. (See procedure 7-2-20 in Troubleshooting.)
4-72
4 SCREWS
SIGNAL
CABLE
POWER
CABLE
Figure 4-56. Removing the HARD DRIVE
CD-ROM DRIVE
HARD DRIVE
JUMPER
FLOPPY
DRIVE
7F3318
2005 July Rev. B
Advertisement
Table of Contents
Troubleshooting
