Table of Contents
Advertisement
7-5-4-3.
Checking the FILM PICKUP MODULE for Problems
- 1. Check that all SUCTION CUPS are spring-loaded and slide back and forth freely in their slots.
- 2. Check that the SUCTION CUPS are finger tight.
- 3. Check the HEEL PAD for adhesion to the HEEL.
- 4. If your inspection reveals problems, advance to paragraph 7-5-6-2 to remove and inspect the
FILM PICKUP MODULE.
7-5-5.
Cycling Film and Observing the Film Transport Process
7-5-5-1.
Preliminary Setup
1. Connect your LAPTOP COMPUTER to the IMAGER (see procedure 7-2-3).
2. Set the SERVICE SWITCH in the Service position and power up the SYSTEM.
3. Use "SecureLink" to connect to the IMAGER.
4. Launch "Service WebLink".
5. When instructed to in the following procedures, start film cycling as follows:
a. Select Diagnostics>Test Prints>MCS Transport.
b. Set the "Copies" window at 5.
c. Click [Run] to cycle film.
2005 July Rev. B
7F3318
Section 7 - - Troubleshooting
7-53
Advertisement
Table of Contents
Troubleshooting
