Table of Contents
Advertisement
8. Measure the height of the image. It should measure 334.8 mm for 14x14--inch film or 346.7 mm for
14x17--inch film.
9. Measure the width of the image.
The width should be equal to the height. If it is not, adjust the Transport Motor Speed until width =
height. 7.5 counts (approximately) = 1 mm. Increasing the speed will make the image wider.
Decreasing the speed will make the image narrower.
10. When width and height are equal, measure the left and right borders and determine how far the image
must be shifted to center the Image on the film.
11. Adjust the SOP Delay to make the right and left borders equal (approximately 4 mm). Changing the
SOP Delay
0.1 second shifts the image 1mm left or right on the film.
±
Note
There is no height adjustment for the image that can be done in the field.
2005 July Rev. B
7F3318
Section 3 - - Adjustments
3-7
Advertisement
Table of Contents
Troubleshooting
