Table of Contents
Advertisement
4-2.
FILM PROCESSOR ASSEMBLY
!
Caution
Any CIRCUIT BOARD that is replaced in the IMAGER must be returned to Kodak for rework or
disposed of properly. CIRCUIT BOARDS contain lead.
4-2-1.
PROCESSOR INTERFACE BOARD
1. On the LOCAL PANEL press FILM Supply> Open Door to close the FILM CARTRIDGE.
2. De--energize the IMAGER and disconnect the POWER CORD.
!
Warning
When the POWER CORD is plugged in, hazardous voltages are present in some areas of the
IMAGER. These voltages can cause severe injury or death.
3. Open the UPPER HOOD and remove the REAR PANEL.
4. Disconnect the DRUM CABLE. (Figure 4-2).
5. Remove 4 ATTACHING SCREWS from the COVER BOX.
6. Lift the COVER BOX free from the PROCESSOR INTERFACE BOARD.
Note
The cover is difficult to remove.
7. Remove 4 ATTACHING SCREWS from the corners of the BOARD, and remove the BOARD.
Figure 4-2. Removing the PROCESSOR INTERFACE BOARD
2005 July Rev. B 7F3318
6
5
Cover Box
Section 4 - - Disassembly/Reassembly
4
7
4-3
Advertisement
Table of Contents
Troubleshooting
