Table of Contents
Advertisement
Service Manual
3. Connect the selected POWER CORD, first to the IMAGER, then to the wall outlet.
2-5-3.
Connecting the IMAGER to the Network
Use the INTERNET DROP CABLE supplied in the ACCESSORIES PACKAGE to connect the IMAGER to
the customer network.
2-5-4.
Securing the IMAGER in its Operating Position
1. Review the Location Requirements for the IMAGER. Refer to the Site Readiness Checklist for the
Kodak DryView 8150 Laser Imager, document 7F3336.
2. Position the IMAGER precisely where it normally will be used.
3. Secure the IMAGER in position.
a. Rotate the STOP clockwise by hand until it touches the floor.
b. Tighten the LOCK NUT finger--tight against the BASE of the LASER IMAGER.
2-20
7F3318
2005 July Rev. B
Advertisement
Table of Contents
Troubleshooting
