Table of Contents
Advertisement
4-7-6.
RF TAG ASSEMBLY (RF TAG INTERFACE BOARD and RF READER BOARD)
Normally the RF TAG INTERFACE BOARD and the RF Reader Board are replaced as an assembly.
!
Caution
To avoid damaging sensitive electronic components, always wear a static strap when handling
CIRCUIT BOARDS. Any CIRCUIT BOARD that is removed from the IMAGER must be returned to
Kodak for rework, or disposed of properly. PRINTED CIRCUIT BOARDS contain lead.
1. Remove the SUPPLY CARTRIDGE, de--energize the IMAGER, and remove the ROLLBACK MODULE
(4-7-1).
!
Warning
When the POWER CORD is plugged in, hazardous voltages are present in some areas of the
IMAGER. These voltages can cause severe injury or death.
2. Carefully turn the ROLLBACK MODULE upside down.
3. Disconnect the 3 ELECTRICAL PLUGS from the RF TAG ASSEMBLY (Figure 4-25).
4. Remove 4 SCREWS and remove the RF TAG ASSEMBLY.
5. After installing the RF TAG ASSEMBLY and installing the ROLLBACK MODULE in the IMAGER,
make sure that both SWITCHES on the RF TAG INTERFACE BOARD are set to the down position.
2005 July Rev. B 7F3318
4
Figure 4-27. Removing the RF TAG ASSEMBLY
Section 4 - - Disassembly/Reassembly
3 (Disconnect three plugs from assembly.)
4-31
Advertisement
Table of Contents
Troubleshooting
