Processor Film Diverter Assembly (Stripper) - Kodak DryView 8150 Service Manual

3-3.

PROCESSOR FILM DIVERTER ASSEMBLY (STRIPPER)

Specification
Gap between DIVERTER BLADE and DRUM END CAPS must be 0.38 to 0.50 mm (0.015 to 0.020 in.).
The DRUM must be at operating temperature for valid check and adjustment.
Required Tools
FEELER GAUGES
M2.5 ALLEN WRENCH
Measurement
1. Raise the UPPER HOOD.
2. Release the 2 DRUM COVER LATCHES and open the DRUM COVER.
!
Caution
The HEAT SHIELD and the surface of the PROCESSOR DRUM are hot. Take care in handling.
3. Use a FEELER GAUGE to check the gap between the DIVERTER and END CAPS of the DRUM. It
must be 0.38 to 0.50 mm (0.015 to 0.020 in.).
4. Rotate the DRUM and check gap consistency around the DRUM.
Adjustment
1. Close the DRUM COVER.
2. Carefully remove and set aside the HEAT SHIELD.
3. Loosen the 2 DIVERTER ATTACHING SCREWS (see Figure 3-4).
4. Set the gap between the DIVERTER and END CAPS of the DRUM to the specification. (You will have
to open the DRUM COVER to check the gap.)
Note
To avoid having to open and close the DRUM COVER for check and adjustment, you may wish to
remove the DRUM COVER. (Use a 2.5 ALLEN WRENCH.)
5. Tighten the 2 DIVERTER ATTACHING SCREWS and recheck the gap. Readjust as necessary.
6. Replace the HEAT SHIELD and close and latch the DRUM COVER.
Heat Shield
2005 July Rev. B 7F3318
Figure 3-4. Adjusting the FILM DIVERTER BLADE GAP
Attaching Screw
and Washer
Felt Pad
Diverter
Section 3 - - Adjustments
3-5