Table of Contents
Advertisement
Service Manual
8-5-31. Error 21-116: Film Pickup Failure
LOCAL PANEL Message
Film Jam in Area 1: Film
Pickup (Alarm sounds)
Summary
The FEEDER BOARD has returned a "pickup fail" message after being commanded by the MCS BOARD
to pick up film. The error is declared if after 2 tries the PICKUP ASSEMBLY has not been able to pick up
up and place a film in the feed area, as indicated by PICKUP POSITION SENSOR S3. All other steps of
the pickup operation must have completed successfully. Otherwise the error associated with the failed
step will be indicated instead of this error.
Result of Error
The system is unable to print. Otherwise it can operate as normal: acquiring, queueing prints, completing
processing, etc.
User Action
1. Touch the [Video] button to view the error video.
2. Touch the [Door] button to open the FRONT DOOR.
3. Clear any jammed film.
4. Close the CARTRIDGE manually.
5. Close the FRONT DOOR.
6. Run test prints to clear fogged film from the IMAGER.
FE Action
1. Use the SERVICE TOOL to check PICKUP POSITION SENSOR S3.
2. Remove the customer FILM CARTRIDGE and load a CARTRIDGE of transport film. Then cycle film
and observe the film pickup operation (see paragraph 7-5-5-3).
3. Remove and inspect the FILM PICKUP ASSEMBLY as necessary (see paragraph 7-5-6-2).
8-34
Log Message
Pickup Position Sensor (S3) failed to
indicate that pickup has reached
feeder nip transfer position
DICOM Message
FILM TRANSP
1--Alert
ERROR
7F3318
Severity
2005 July Rev. B
Advertisement
Table of Contents
Troubleshooting
