5. Remove:
3 SCREWS
•
PLATE
•
FLAT
CABLE
2 SCREWS
FLYWHEEL
END CABLE
CONNECTOR
Note
Do not disconnect the FLAT CABLE.
6. Lift the PLATE and FLAT CABLE outside of the IMAGING ASSEMBLY.
7. Remove:
2 SCREWS from the end of the IMAGING ASSEMBLY by the FLYWHEEL
•
2 SCREWS from the other end of the IMAGING ASSEMBLY
•
2 BLOCKS
•
Note
Keep the HOME SENSOR CABLE with the IMAGING ASSEMBLY.
8. Disconnect:
END CABLE CONNECTOR
•
HOME SENSOR CABLE
•
9. Lift the TRANSLATION ASSEMBLY from the IMAGING ASSEMBLY and set it down.
10. Remove the OPTICS MODULE.
2005 July Rev. B 7F3318
HOME
SENSOR
CABLE
RAIL PINS
IMAGING ASSEMBLY
Section 4 - - Disassembly/Reassembly
PLATE
2 SCREWS
2 BLOCKS
TRANSLATION
ASSEMBLY
4-59