Table of Contents
Advertisement
Service Manual
14. Click Upload. The progress bar at the bottom of the screen indicates the uploading progress.
15. A new screen displays the selected file name and path in the Systems File--Filter window.
16. Under File Transfer, click Download.
17. In the System File Name window, locate the file. Check the box in front of the file name.
Scroll down to the bottom of the screen and click Download to place the file in the ES repository.
When the File Download window indicates that the file download has been submitted, click OK.
18. Under Summary, click View to verify that the file is in the ES repository.
19. Check that the Pending Messages/File Repository box contains a date and time (EST) for the
generated file. Change the refresh interval to 5 seconds and click Start Auto Refresh.
After the file has been downloaded, the Pending Messages box will indicate that there are no pending
messages.
20. Select Administration>System tabs and click System Log to display error messages. If there is a
downloading error, contact RMS Support or wait and try again.
21. Select Applications>Diagnostics tabs.
22. Under Properties, click Get Values.
23. In the Readable Properties window, check the Property box. Click Request.
24. Change the refresh interval to 5 seconds and click Start Auto Refresh. Under Remote Access, click
Connect to Device.
25. The Remote Access screen appears. Wait for Status column entries to display Completed .
26. Click Connect SecureLink.
27. Click OK (no user name or password is needed).
28. The Secure Link Password screen appears. Enter the Secure Link password.
29. Enter the IP Address (127.0.0.1) in the IP Address box of the Secure Link screen.
30. Enter the port number displayed on the Remote Access Session screen (5959) into the Port box of the
Secure Link screen.
31. Click Connect to connect Secure Link to the Imager. The connection icon indicates that the Secure
Link connection to the Imager has been completed.
32. Launch the WebLink 8150 Service Tool. Select Diagnostics>Scripts.
33. On the Scripts page, click Local. Browse to the local copy of the TriggerMPDB.vbs file and highlight
the file. This file is provided on your laptop to enable you to perform this process.
34. Click Open and click Run.
35. Select the Scripts RunTime tab.A "Pass" message appears when the file has been copied to
trigger.enca. If the ACMS Query did not provide the required modality parameters, configure the
Imager by manually entering the parameters using the Modality Parameter Values Capture process.
7-34
7F3318
2005 July Rev. B
Advertisement
Table of Contents
Troubleshooting
