Table of Contents
Advertisement
Service Manual
4-9.
FEED ROLLER ASSEMBLY
4-9-1.
FEED ROLLER MODULE
1. Remove the SUPPLY CARTRIDGES.
!
Warning
When the POWER CORD is plugged in, hazardous voltages are present in some areas of the
IMAGER. These voltages can cause severe injury or death.
2. De-energize the IMAGER and disconnect the POWER CORD.
3. Open the FRONT DOOR and remove the REAR PANEL.
4. Check that the FILM PICKUP MODULE is in the up position (see paragraph 4-6-1, step 5).
5. Remove 2 SCREWS from the front (see Front View in Figure 4-32).
6. Disconnect 3 ELECTRICAL CABLES (see Rear View in Figure 4-32).
7. Remove 2 SCREWS from the back side (Rear View), while supporting the FEED ROLLER MODULE.
8. Carefully lift and remove the MODULE from the machine.
5
4-36
FEED ROLLER
MODULE
Figure 4-32. Removing the FEED ROLLER MODULE
DANGER
96- - 0000- - 3663- - 0 B
FrontBackUpper
7
Remove 4
CABLES
6
7F3318
2005 July Rev. B
Advertisement
Table of Contents
Troubleshooting
