Table of Contents
Advertisement
Service Manual
!
Caution
Do not to damage wiring when you slide the ROLLBACK MODULE out. The TENSION SPRINGS
on the front and back of the MODULE may catch wiring if you are not careful.
13. Carefully slide the ROLLBACK MODULE out the front of the IMAGER and set it on a work surface.
Reassembly
Reassembly is essentially the reverse of disassembly. Make sure when you install the ROLLBACK
MODULE that the bottom left of the assembly slides in along the SLIDE TRACK on the BASE (Front
View).
!
Caution
Do not to damage wiring when you slide the ROLLBACK MODULE in. Make sure all CABLES are
routed properly after reassembly.
4-26
7F3318
2005 July Rev. B
Advertisement
Table of Contents
Troubleshooting
