Error 21-125, 22-125, Or 23-125: Feed Roller Nip Failure - Kodak DryView 6800 Diagnostics Manual

DIAGNOSTICS
30JUL07

Error 21-125, 22-125, or 23-125: FEED ROLLER Nip Failure

8F2919
Page
134 of 326
Messages
xxxxx Supply: Internal
Hardware Failure
(Alarm sounds)
Description
Note
UPPER DRAWER (U) = 21. MIDDLE DRAWER (M) = 22. LOWER DRAWER (L) = 23.
This error occurs if the FEED ROLLER POSITION SENSOR (S4x) does not change from
unblocked to blocked when the ROLLER is opening, or from blocked to unblocked when the
ROLLER is closing. Either the FEED ROLLER OPEN/CLOSE MOTOR (M1x) did not power
on to move the ROLLER, or the SENSOR did not detect the motion. The error is cleared
when the IMAGER is power cycled.
Result of Error
The system cannot make a print from the SUPPLY DRAWER. The SPOOLER is able to
receive and queue jobs, and print from any other available SUPPLY DRAWER.
User Action
1 Restart the LASER IMAGER from the LOCAL PANEL.
2 If the error occurs again, call Service.
FE Action
Do the actions below in sequence. If an action provides a resolution, do not continue with the
other actions.
1 De-energize then energize the LASER IMAGER.
LOCAL PANEL LOG
xxxxx Supply: Feed Roller
Sensor (S4) failed to detect
feed roller open/closed
position.
Status Messages and Error Codes
DICOM SEVERITY
FILM TRANS 1-Alert
ERR