Setting Ip Parameters: Phaser 360 Printer Front Panel - Tektronix Phaser 740 Setup Manual

8
Setting the Printer's IP Addressing Parameters

Setting IP parameters: Phaser 360 printer front panel

58
PhaserShare Networking
9.
Return the printer to normal operation:
a.
Press until
display.
b.
Press again.
If you have changed any parameters that require a printer reset to
take effect, you will be prompted to reset the printer. If you press
Confirm, the printer resets. To return to normal operation without
resetting the printer, press
top line of the display. Press
normal operation, but the changes you have made will not take
effect until the next time the printer is reset.
If you have not changed any parameters that require a printer
reset, press
N
O T E
When you set the IP addressing parameters from the front panel, the selections
for DHCP/BOOTP and RARP are automatically set to Disabled.
1.
Press Menu; the front panel displays Help Pages.
2.
Press ----> or <---- until the front panel displays Network
Settings.
3.
Press Menu until the front panel displays TCP/IP.
4.
To set the IP address:
a.
Press Menu again; the front panel displays Enable Interface.
b.
Press ----> until the front panel displays TCP/IP Address.
c. Press Menu to display the IP address. For example:
192.2.194.101
Increment Shift
N
O T E
Setting the IP address to 000.000.000.000 causes the printer to use Dynamic
Address Resolution to set its IP address (see "Setting IP parameters: RARP or
BOOTP" on page 61).
appears on the top line of the
Network Settings
; Printer Menu appears on the
again; the printer returns to
again; the front panel displays Ready.
Select