Connecting The Printer To A Pc; Direct Connection To A Pc; Networked Connection Using The Ethernet Port; Networked Connection Using The Token Ring Port - Tektronix PHASER 560 Service Manual

Connecting the printer to a PC

Downloaded from www.Manualslib.com
3. Turn on the printer. During the printer's boot-up process, the printer's
network name is displayed in the Mac's Chooser and its node address
is resolved with the network. If the network features multiple zones,
the network router assigns the printer a default zone name. The
printer's configuration page lists the name. The topic "Printing the
configuration page" on page 9-4 explains printing this page.

Direct connection to a PC

1.
Turn off the printer. Turn off the PC.
2.
Attach the parallel interface cable to the host computer. Attach the
other end to the printer. Alternatively, attach the serial cable to the
host computer's serial port. Attach the other end to the printer's serial
port. The serial connections requires that the Serial/LocalTalk
network card be installed.
3. Turn on the printer and the PC.

Networked connection using the Ethernet port

Note For an Ethernet connection, the printer must have the Option P1
Ethernet Network Card installed.
In Novell NetWare networks, the printer is connected to the network in the
same manner as the workstations using an Ethernet connection.
1.
Turn off the printer.
2.
Connect the interface cable to the printer's ThinNet or TwistedPair
Ethernet connector. Use only one connector.
3. Turn on the printer.

Networked connection using the Token ring port

Note For Token Ring networks, the Phaser 560 must have the Option P4
Token Ring Network Card installed.
1. Turn off the printer.
2. Connect the interface cable to the printer's appropriate Token Ring
connector.
3. Turn on the printer.
manuals search engine
Installing the Printer and Drivers
Service Manual
2
2-9