Table 1-6 Electrical Specifications; Table 1-7 Environmental Specifications - Tektronix Phaser 550 Service Manual

1
General Information
1-16 Phaser 550 Color Printer

Table 1-6 Electrical specifications

Characteristic
Primary line voltages
Primary voltage
frequency range
Power consumption
Primary voltage fusing
Secondary DC voltages
RF emissions

Table 1-7 Environmental specifications

Characteristic
Temperature
Operating
Non-operating
Storage
Humidity
Operating
Non-operating
Altitude
Operating
Non-operating
Vibration/shock
Operating
Non-Operating
(vibration)
Non-operating (shock)
Acoustic Noise
(operating)
Specification
87 to 128 VAC (115 VAC or 100 VAC nominal); 174 to 260
VAC (220 VAC nominal)
47 to 63 Hz
60 watts (fuser off), 850 watts (fuser on) during Ready state,
950 watts during Warm-up, 45 watts during Energy Star state
110 VAC configuration – 10 amp
220 VAC configuration – 6.3 amp
Image processor:
+ 5 VDC ± 0.25 (1A minimum, 6 A maximum)
± 12 VDC ± 0.6 (100 mA max)
Print engine:
+ 5V ± 0.25 (2.2 A max)
+ 12V ± 0.25 (0.4 A max)
- 12V ± 0.25 (0.1 A max)
+ 24V ± 0.25 (3.0 A max)
Both 110 and 220 VAC-configured instruments pass these
standards: FCC Part 15 Class B
VDE Class B
EN55022 (CISPR 22) Class B
VCCI (CISPR 22) Class B
Specification
o o o o
10 to 32.5 C (50 to 91 F)
o o o o
0 to 40 C (32 to 104 F)
o o o o
-20 to 60 to F)
C (-4 140
Media should be acclimated 24 hours before using in the
printer.
10 to 80% relative humidity, non-condensing
10 to 90% relative humidity, non-condensing
Media should be acclimated 24 hours before using in the
printer.
0 to 2500 m (8,000 ft.) at 25
0 to 15000 m (50,000 ft.)
(Fuser maximum 4000 m (13,300 ft.)
May drop any side or corner 50 mm (2 in.) without impairment
of subsequent operation.
On five mutually perpendicular axes: 0.5 g, 25-minute sweep,
5 to 200 to 5 Hz, 100 to 200 sec./sweep cycle. No resonant
frequencies below 50 Hz.
30 g, trapezoidal flared pulse, 20 msec each axis.
Average sound level (LEQ) is less than 53 dbA. Peak noise in
standby mode is 47 dbA.
o
C