Tray Sensor Circuit Board; Figure 8-25 Removing The Tray Sensor Circuit Board - Tektronix Phaser 440 Service Manual

8
FRU Disassembly/Assembly

Tray sensor circuit board

8-32 Phaser 440 Color Printer
Tools required
#1 POSIDRIV® screwdriver
1. Power down the printer and remove the power cord.
2.
Remove the paper tray and front access cover panel
3. Remove the right-side cabinet panel.
4.
Disconnect the wiring harness leading to the tray sensor assembly.
5. Remove the two screws securing the tray sensor assembly to the side
of the print engine.
6. Remove the screw securing sensor board to the sensor assembly
bracket.

Figure 8-25 Removing the tray sensor circuit board

Reverse these steps to reinstall the tray sensor assembly.
4
Tray sensor
bracket
6 Tray sensor
circuit board
9015-18