Windows; Power Window Controls - Jeep GRAND CHEROKEE L 2023 Owner's Manual

The wireless charging pad is equipped with an
anti-slip mat to hold your mobile phone in place,
and an LED indicator light.
LED Indicator Status:
No Light: Charging pad is idle or searching for a

device.
Blue Light: Device is detected and is charging.

Red Light/Flashing: Internal error or foreign

object is detected.
Important Notes Regarding This Vehicle's Wireless
Charging Pad:
All vehicle doors must be closed for the wireless

charging pad to operate.
If the phone moves on the pad causing the red

light to illuminate, the phone will have to be
picked up and placed back on the charging pad
to resume charging.
Wireless charging is not as fast as when the

phone is connected to a wired charger.
The phone's protective case must be removed

when placed on the wireless charging pad.
iPhone® 12 (including iPod®) is equipped with

software to protect the device from overheating.
When the software is active, the rate of charge
is slowed down to protect the device.
Phones must always be placed on the wireless

charging pad within the outline shown on the
pad so that its charging parts connect with the
charging coils of the system. Movement of the
phone during charging may prevent or slow the
rate of charge.
Having multiple applications open on the phone

while charging will reduce the charging effi-
ciency, and may even shut down an application
that is actively running (i.e. Apple CarPlay®).
This may also cause the phone to overheat.
Wireless chargers may implement certain

methods to prevent the phone from overheating
during charging such as slowing down the rate
of charge. In certain instances, the device may
shut down for a brief period of time (when the
device reaches a certain temperature). If this
happens, it does not mean there is a fault with
the wireless charing pad. This may just be a
protective measure to prevent damage to the
phone.
CAUTION!
The key fob should not be placed on the
charging pad or within 6 inches (15 cm) of it.
Doing so can cause excessive heat buildup and
damage to the fob. Placing the fob in close
proximity of the charging pad blocks the fob from
being detected by the vehicle and prevents the
vehicle from starting.
GETTING TO KNOW YOUR VEHICLE

WINDOWS

P W C
OWER INDOW ONTROLS
The power window controls, located on the driver's
door trim panel, operate the window movement for
all four power windows.
There is a single switch on the front passenger
door and rear passenger doors which operates the
windows for only that door.
Driver's Door Power Window Switches
NOTE:
The power window switches remain active for up

to 10 minutes after the ignition has been placed
in the OFF position. Opening a vehicle front door
will cancel this feature.
81
2