Table of Contents
Advertisement
66
GETTING TO KNOW YOUR VEHICLE
NOTE:
When you push the button on the liftgate, either
only the liftgate will unlock or all doors and the
liftgate will unlock, depending on the selected
setting in the Uconnect system Ú page 152.
Passive Entry/Lock Button Location
1 — Electronic Liftgate Release
2 — Passive Entry Lock Button Location
NOTE:
Use the power door lock switch on either front door
trim panel or the key fob to lock and unlock the
liftgate. The manual door locks on the doors and
the driver's door lock cylinder will not lock and
unlock the liftgate.
WARNING!
Driving with the liftgate open can allow
poisonous exhaust gases into your vehicle. You
and your passengers could be injured by these
fumes. Keep the liftgate closed when you are
operating the vehicle.
T
L
/C
T
L
O
OCK
LOSE
HE
IFTGATE
To manually close the liftgate, grab the liftgate
closing handle and pull in a downward motion to
close the liftgate.
With a valid Passive Entry key fob within 5 ft
(1.5 m) of the liftgate, pushing the Passive Entry
lock button, located next to the electronic release
handle, will lock the vehicle.
The power liftgate may be closed by pushing the
button, located in the upper left trim in the liftgate
opening. This button cannot be used to open the
liftgate.
NOTE:
The liftgate unlock feature is built into the elec-
tronic liftgate release handle.
P
L
— I
E
OWER
IFTGATE
F
QUIPPED
The power liftgate may be opened by
pushing the electronic liftgate release
handle Ú page 23, or by pushing the
liftgate button on the key fob. Push the
liftgate button on the key fob twice within five
seconds to open or close the power liftgate.
NOTE:
When using the liftgate button on the key fob to
open the liftgate while the vehicle is locked, only
the liftgate will unlock leaving the other doors to
remain locked. Closing the liftgate will not relock
the liftgate. The lock button on the key fob, or
the Passive Entry lock button must be pushed to
relock.
If the electronic release handle is used to unlock
and open the liftgate and all the doors unlock,
the liftgate and vehicle doors must be locked
again. Use the key fob, Passive Entry lock
button, or the power door lock switches on the
front door panels.
The power liftgate may also be opened or closed by
pushing the liftgate button located on the front
overhead console. If the liftgate is fully open, the
liftgate can be closed by pushing the liftgate button
located on the left rear trim panel. If the liftgate is
in motion, pushing the button again will reverse the
liftgate.
When the liftgate button on the key fob is pushed
two times, the turn signals will flash to signal that
the liftgate is opening or closing (if Flash Lamps
with Lock is enabled in the Uconnect Settings), and
the liftgate chime will be audible. The chime can be
turned on or off through the Uconnect Settings
Ú page 152.
Advertisement
Table of Contents
