No Teis On Loop; Sampling; Dns On Loop - Nortel Modular ICS 6.0 Installer's Manual

No TEIs on loop

Press ADD to program up to eight TEIs to this loop.

Sampling

Press CHANGE to select the sampling used by an S loop:
• Fixed — if two or more S-interface devices use the loop
and the length of the loop is less than 200 m (650 ft.), select
Fixed.
• Adaptve — if two or more S-interface devices use the
loop and the length of the loop is greater than 200 m (650
ft.), select Adaptve.
If one S-interface device is using the loop, the length of the
loop can be up to 1000 m (3,250 ft.) and the rate should be set
to Adaptve.
The BRI card must be disabled under Module status in
Maintenance programming, before you can change this
setting. You can change the setting if the card has not yet been
installed in the ICS slot.

DNs on Loop

Press ≠ to view and program the ISDN DNs assigned
to the loop.
P0992638 03
Hardware / 475
Installer password required
Installer password required
Installer password required
Modular ICS 6.0 Installer Guide