Nortel Modular ICS 6.0 Installer's Manual page 459

Nortel modular ics 6.0 digital system package

Hide thumbs Also See for Modular ICS 6.0:

Table of Contents

3. Press CHANGE to change the mapping that is applied to

incoming calls of this service type to obtain the received

digits. In all cases, the received digits are used to find a

target line or to activate Remote Access.

None — No mapping is applied. The received number

length determines the number of digits of the Called Party

Number which will be used as received digits.

Note: If there is no called party number, which may occur

with some FX calls, the call will ring at the incoming

trunk Prime set.

All — Allows you to define the received digits used for all

calls with this service type, regardless of the called party

number or service identifier (SID). For this option, all calls

with this service type on this PRI will ring the same target

Map table — Allows you to associate different received

digits with different calls of this service type, depending

on the call party number and/or the service identifier.

Incoming calls that do not match any entry defined in the

map table will ring at the prime set. Depending on the

service type and the protocol, you may be able to map the

called party number and the service identifier.

The following table shows the different options.

Modular ICS 6.0 Installer Guide

Hardware / 459

Troubleshooting