Receiving And Sending Connected Name; Network Name Display Interactions - Nortel Modular ICS 6.0 Installer's Manual

430 / System prgrming
• If the Calling Party Name is unavailable it may be
displayed on the Called Party set as Unknown name.
• The system supports sending the calling party name, which
is the Business Name and Set Name concatenated together,
on calls originated by the Norstar system.
For information on programming your Feature assignment,
see Feature assignment (CLID alignment) on page 330.
The Set Name will only be sent if the OLI for the Set is
configured. See OLI # on page 315.

Receiving and Sending Connected Name

Outgoing calls record the Connected Name on outgoing calls.
The Connected Name is stored and displayed on the Norstar
set. In order for this to work you need to set the Called ID to
Yes. See Called ID on page 332.
The system also supports sending the Connected Name, which
is the Business and Set Name concatenated together, with
incoming calls.
If the call is answered by a hunt group, the hunt group name is
used instead of the set name.
The Connected Name is a transient display that appears for
about three seconds.

Network Name Display interactions

Calling and Connected Name information (if available) is
passed between trunks with Selective Line Redirection (SLR).
Only Calling Name information is passed between trunks in
cases where Direct System Inward Access (DISA) has resulted
in tandeming of trunks.
Modular ICS 6.0 Installer Guide P0992638 03