Entering Programming For Installers - Nortel Modular ICS 6.0 Installer's Manual

Hardware
Maintenance
Usage metrics
*For information about programming for Companion, see the
Modular ICS Companion Installer Guide.

Entering programming for installers

1. Enter the installer codes on a programming set by pressing
² ¥ ¥ ‚ ¯ ö ì é í
which is the same as
The display shows Password:.
2. Enter the Installer password.
The default password is
The display shows Terminals&Sets. Three triangular
indicators º appear on the vertical display between the
rows of buttons.
3. Place the programming overlay over the buttons pointed to
by the indicators º.
P0992638 03
Allows you to configure the Trunk
Cartridges and BRI cards used by the
system.
Allows you to view diagnostic
information about the system and
provision BRI cartridges.
Provides statistical information on Hunt
groups.
,
² ¥ ¥ Û ß ß Ü Ý Ý
(266344).
CONFIG
Programming / 305
.
Modular ICS 6.0 Installer Guide