Event Message 799 - Nortel Modular ICS 6.0 Installer's Manual

518 / Event messages
Event message
Evt:698
EVT799-00040B
Evt:822
Evt:882
Evt:883
Evt:992

Event message 799

Event message 799 indicates a call processing error has
occurred on an ISDN line. The event number is followed by a
number representing the line or loop number, and a code for
the type of error.
EVT799-XXXX YYS7
Error
code
01
02
03
04
05
Modular ICS 6.0 Installer Guide
The event message is recorded when...
incorrect software key entered
S8
a call processing error on the fourth BRI loop; see
S7
Event message 799 on page 518.
Alarm code 63 is sent because there are no DTMF
S8
receivers for an incoming call
mobility data re-evaluation sequence initiated
S9
an invalid dial pulse signal was received by the DTI
S4
auto attendant error
S6
In this example, the error has occurred on line
XXX and the error code is YY.
Internal software error. Cannot acquire the B-channel from
the B-channel arbitrator.
Internal software error. There is no free line available for the
call.
A call that is not on the B-channel has been attempted.
These kind of calls are part of EKTS service, which is not
supported by this version of the software. Check with your
service provider to make sure your package does not
include EKTS service.
Internal software error. Failed to instantiate on the chain.
Internal software error. Activation procedure failed.
Meaning
P0992638 03