Nortel Modular ICS 6.0 Installer's Manual page 291

7. Press OK to proceed with the copy. This step is not
necessary when you are copying to a single telephone.
You can also use COPY to duplicate the settings found in the
individual subheadings. The button is available in
Capabilities
and will copy only the settings included in the
features
subheading.
If you press COPY in one of these subheadings, you will not be
asked to decide if user data will be copied. Otherwise, the
procedure is the same.
Tips -
of a range, follow the steps for making a single copy and keep
entering new numbers at the Copy to: display.
Depending on the activities going on in the system, a copy may
not take effect for a while. The brief display you see once you
have finished a copying session does not indicate the process
is complete.
You can leave the programming session even if the copy has
not been completed. If you exit programming, copying will
continue uninterrupted until it is complete.
Tips -
completion of the copying process. For more information, see
Event messages on page 514.
Some programming settings allow you to choose a delay
according to the number of rings. The ring counts used are
based on a North American standard of six seconds per ring
cycle. The actual delay time may be different for a device other
than a Norstar telephone.
P0992638 03
,
User prefernces
To copy to a group of telephones which are not part
Event messages capture both the start and
Copying telephone programming / 291
, and
Restrictions
Line access
Telco
Modular ICS 6.0 Installer Guide
,