Nortel Modular ICS 6.0 Installer's Manual page 135

If you are using the centralized voice message system from a
Meridian 1 system, you require the following programming on
the M1:
M1 programming in LD 17
• NASA set to Yes
• NCRD set to Yes
Verifying NASA is Active
• Overlay 22, LD 22
• REQ: PRT
• TYPE: ADAN DCH (slot number)
• NASA should be set to yes
If NASA is Disable the
not on: D channel
• Overlay
96, LD
96
• REQ:
CHG
• TYPE:DIS
DCH
Verifying NCRD
• Overlay 20, LD 20
• REQ: PRT
• TYPE: TIE
• CUST: 0
• Route: Enter the route
defined in LD 20
• Keep pressing enter
until all values are
displayed. Check if
NCRD is yes.
P0992638 03
Private networking using PRI SL-1 / 135
Disable the loop
• Overlay 60, LD 60
• REQ: CHG
• TYPE: DISL (slot
number)
If NCRD is set to no
• Overlay 16, LD 16
• REQ: CHG
• TYPE: RDB
• CUST: 0
• ROUT: (route number) from LD 20
• Keep pressing enter until you get NCRD and
type Yes
• Keep pressing enter until you get the REQ
prompt again
• TYPE: end
Program the D channel
• Overlay 17, LD 17
• REQ: CHG
• TYPE: ADAN
• ADAN: CHG DCH (slot
number)
• Keep pressing enter
until you get to NASA
• TYPE: yes
• TYPE: end
Modular ICS 6.0 Installer Guide