460 / Hardware
Discon timer
Disconnect timer allows you to specify the duration of an
Open Switch Interval (OSI) before a call on a supervised
external line is considered disconnected.
Press CHANGE to select the setting: 60, 100, 260, 460, or 600
milliseconds.
Tips -
with the Trunk mode setting. See Trunk/Line data on page 333.
This setting must match the setting for the line at the central
office (CO).
This setting only appears for DTI (T1) and Loop Trunk
Cartridges.
Answer timer
Answer timer allows you to set the minimum duration of an
answer signal before a call is considered to be answered.
Press CHANGE to select the setting: 1, 2, 3, 4 or 5 seconds.
Note: This setting only appears for DTI (T1) and E&M Trunk
Cartridges
CO fail
Select the carrier failure standard used by your T1 or PRI
service provider.
Press CHANGE to select the setting: TIA-547A or TR62411.
Tips -
Consult your T1 or PRI service provider for the proper
setting.
Modular ICS 6.0 Installer Guide
Disconnect Supervision is assigned to each line
.
This setting only appears for DTIs.
Installer password required
Installer password required
P0992638 03