Remote System - Nortel Modular ICS 6.0 Installer's Manual

152 / Private networking using PRI SL-1
4. Press ≠. The prompt displays Line assignment.
5. Enter the target line number for the Auto Attendant
system.
6. Press CHANGE to change the setting for each line to one of
the following: Unassigned, Ring only, Appr&Ring, and
Appr only.
7. Press – until you reach the top level, then press
'. The prompt displays Lines.
8. Press ≠. The prompt displays Show line.
9. Enter the target line number you entered in step 5.
10. Press ≠. The prompt displays. The prompt displays
Line Type.
11. Press '. The prompt displays Rec'd #.
12. Enter the DN for the Auto Attendant system.
13. Exit programming.

Remote system

On the nodes that are not directly connected to the central Auto
Attendant system, you need to use the Telco Features headings
to identify the route to the system.
1. After you enter your password, press ' until the
prompt displays Telco Features:
2. Press ≠. The prompt displays VMsg Center
tel#s.
3. Press ≠. The prompt displays VMsg Center 1.
4. Press ≠. The prompt displays Use:.
5. Press CHANGE to until you reach Routing tbl.
Modular ICS 6.0 Installer Guide P0992638 03