Off-Core Dti Card; Replacing A Modular 8X24 Ksu - Nortel Modular ICS 6.0 Installer's Manual

Nortel modular ics 6.0 digital system package

Hide thumbs Also See for Modular ICS 6.0:

Table of Contents

DIP switch setting

* Reserved for future development

Off-core DTI card

MICS 6.0 provides the opportunity to expand the number of

DTI cards in your system by adding a DTI card to the

expansion modules in a midi or maxi system. The card must be

installed in either module 3 or 4 on a midi system. On the maxi

system, the card can only be installed in module 7 or 8. One

DTI card requires the entire module resources, so it is installed

in the first slot of the module, and the other two slots must be

left empty. The off-core DTI is configured in the same way as

the other DTIs on your system.

This card is supported for profiles 1 and 4.

Equipment note: The DTI card released in conjunction with

MICs 6.0 can be used either on or off-core. However, any

previous versions of the DTI card can only be used on the core

KSU hardware.

If you are upgrading your old KSU (8X24) and adding digital

T1 trunks to your new system (0X32 ICS):

1. Verify your system programming, and update your

Programming Record.

2. Follow the procedures outlined in Installation on page 209

for installing a new system.

Country profile

Planning the installation / 201

Modular ICS 6.0 Installer Guide