Pri Dialing Plan Example For Two-Way Did - Nortel Modular ICS 6.0 Installer's Manual

Nortel modular ics 6.0 digital system package

Hide thumbs Also See for Modular ICS 6.0:

Table of Contents

108 / Dialing plans

To Public Network:

Routing Service

PRI dialing plan example for two-way DID

The following list shows the steps involved in configuring a

dialing plan for two-way DID which uses a Public service. In

this example the user dials the prefix 8 to place a call over a

Note: Call-by-call is not needed to have two-way DID.

in Hardware programming, configure the DTI card (PRI)

to use a Public protocol

for incoming calls you need to program target lines to

match the DID digit that is being received on the PRI

set Dial Out to None

select PRI-A as the line pool

Modular ICS 6.0 Installer Guide